Live updating opeating systems using virtualization updating a clob field

Rated 3.87/5 based on 678 customer reviews

The system boots from the CD and displays a screen of instructions with a boot: prompt at the bottom.

Refer to "BIOS setup" on page 25 if the system does not boot from the CD.

After a while (up to a few minutes, depending on the speed of the system), the installer displays a graphical or pseudographical display, depending on the system you are installing and the commands you gave at the boot: prompt.

The balance of this section covers the commands you can give in response to the boot: prompt.

Checking the CDs takes a few minutes and can save you hours of aggravation if the installation fails due to bad media.

From this screen, you can verify that the installation CDs do not have any errors.Unless you are having problems with the installation or have special requirements, you can skip to the next section, "The Anaconda Installer" on page 46.All the commands (except for memtest86) you can give in response to the boot: prompt consist of the word linux followed by an argument that is passed to the Anaconda installer. For example, to install Linux in text mode using a terminal running at 115,200 The next command installs Red Hat Linux in graphical mode (by default) on a monitor with a resolution of 1024x768, without probing for any devices.You can display a virtual console by pressing to return to the previous screen.Initially, each of the graphical installation screens is divided into two columns: a narrow help column on the left and information and prompts about the installation on the right.

Leave a Reply